Download  Print this page

Dell 4100MP Safety Instructions Page 2

Dell 4100mp projector user's guide.
Hide thumbs


Back to Contents Page
About Your Projector: Dell™ 4100MP Projector User's Guide
Main Unit
Control Panel
Connection Ports
Remote Control
Single chip 0.7" Texas Instruments DLP™ technology
High contrast, double data rate (DDR) digital micro mirror device
True XGA (1024 x 768) native resolution
6.5 lbs (2.95 kg) lightweight compact design
2200 max. ANSI lumens brightness *
2000:1 full on / full off contrast ratio
1.2x manual zoom lens
Built in 2W stereo speakers
Auto image re-sizing (Auto-Sync) to 1024x 768 full screen with scaling compression compatibility for UXGA, SXGA+, SXGA, XGA,
Great connectivity -- Multiple PC and High Definition inputs (via M1-DA and RGB), S-Video, Composite Video (RCA), Component Video,
and RS232
Preset and user defined video modes for optimum video and graphic settings
PIP (Picture In Picture) for dual signal source display
LCD display for real time projector status
Self-diagnostic for video troubleshooting
State-of-the-art motion adaptive hardware de-interlacing with 3:2 and 2:2 pull down
250-watt user-replaceable UHP 1500-hour lamp
Eco Mode allows end user to extend lamp life to 3000 hours by reducing the lamp wattage and brightness.
Compatibility with Macintosh® computers
Compatibility with NTSC, NTSC4.43, PAL, PAL-M, PAL-N, SECAM, and HDTV (1080i, 720p, 576i/p, 480i/p)
High-definition TV compatibility
Full featured RF Cordless remote control with mouse and laser pointer
User-friendly, multi-language on-screen display (OSD)
Advanced horizontal and auto vertical electronic keystone correction
Semi-auto electronic keystone correction for image distortion
Remote projector control from PC via RS232 port
User-friendly control panel with backlight buttons
Hard foam drop tested carrying case included
Plug and play for photo image display from the option for memory card reader (Memory card module sold separately)
Smart lens cap power management (Patent pending)
*Based on ANSI/NAPM IT7.228-1997 tests of 100 units, December 2003, with average ANSI Lumens 2000. Bulb brightness degrades with usage. Dell
recommends replacing your bulb after 1500 hours usage.
Your projector comes with all the items shown below. Ensure that you have all the items, and
Main unit
2.0m S-video cable
3.0m Power cord
1.8m M1-A to D-sub/USB cable
1.8m M1-A to HDTV cable
contact Dell
if anything is missing.
1.8m Composite Video cable


Table of Contents

   Also See for Dell 4100MP

   Related Manuals for Dell 4100MP

Comments to this Manuals

Symbols: 0
Latest comments: