At Command Issuance (I/O Registers Setting Contents) - Fujitsu MHE2043AT Product Manual

Interface
When the SET MULTIPLE MODE command operation is completed, the device
clears the BSY bit and generates an interrupt.
1F7
1F6
1F5
1F4
1F3
1F2
1F1
1F7
1F6
1F5
1F4
1F3
1F2
1F1
After power-on or after hardware reset, the READ MULTIPLE and WRITE
MULTIPLE command operation are disabled as the default mode.
The mode established before software reset is retained if disable default (Features
Reg. = 66h setting) has been defined by the SET FEATURES command. If
disable default has not been defined after the software is the READ MULTIPLE
and WRITE MULTIPLE commands are disabled.
The parameters for the multiple commands which are posted to the host system
when the IDENTIFY DEVICE command is issued are listed below. See
Subsection 5.32 for the IDENTIFY DEVICE command.
5-42

At command issuance (I/O registers setting contents)

(CM) 1 1
H
(DH)
H
(CH) xx
H
(CL) xx
H
(SN) xx
H
(SC) Sector count/block
H
(FR) xx
H
At command completion (I/O registers contents to be read)
(ST) Status information
H
(DH)
H
(CH) xx
H
(CL) xx
H
(SN) xx
H
(SC) Sector count/block
H
(ER) Error information
H
0 0 0 1
DV xx
DV xx
1 0
C141-E057-01EN