Cable Connector Requirements; Recommended Components For Connection - Fujitsu MAB3045 Product Manual

4.3.3

Cable connector requirements

Table 4.3 lists the recommended components cable connection.
Table 4.3
Applicable
model
MAx3xxxSP SCSI cable (CN1)
Power supply cable
(CN1)
External operator
panel (CN1)
External operator
panel (CN7)
MAx3xxxSC SCSI connector
(CN1)
(1) SCSI cable
All SCSI devices on one bus are daisy-chained with an SCSI cable. A terminating resistor
must be mounted in the SCSI device at each end of the SCSI cable.
Because an SCSI terminating resistor module has been mounted in the IDD of single-ended
type SCSI at factory shipment, it must be set to not-connection when the IDD is not connected
at either end of the SCSI cable. See Section 5.3 for details.
The maximum number of SCSI devices that can be connected to the SCSI bus is 16 for the 16-
bit SCSI, including the host adapter, IDD, and other SCSI equipment.
For the 16-bit SCSI, the connector for the SCSI cable must be an unshielded 68-contact socket
having 34-contact rows spaced 1.27 mm (0.05 inch) apart. (See Figure 4.26.)
4 - 24

Recommended components for connection

Name Par number
Cable socket 786090-7
(closed-end type)
Signal cable —
Cable socket 1-480424-0
housing
Contact 60619-4
Cable 60617-4
Cable socket FCN-723J012/2M
housing
Contact FCN-723J-G/AM
Cable AWG26 to 34
Cable socket FCN-723J016/2M
housing
Contact FCN-723J-G/AM
Cable AWG28
Connector 787311-1
C141-E035-02EN
Manufacturer Reference
(Figures 4.23
and 4.28)
AMP S1
—
AMP S2
Fujitsu Limited S3
Fujitsu Limited
Fujitsu Limited S4
Fujitsu Limited
AMP