Table of Contents
Advertisement
(2) Mounting the Clamps and Connecting the Imprinter cable
Two types of clamps are used for securing the imprinter cable. Mount the clamps as follows:
Note: The imprinter cable should be connected after the clamps have been mounted.
Clamps (black)
Use these clamps (black) to fix the imprinter cable.
Insert the clamps into the holes on the back of the
1
scanner.
Clamp (white)
The clamp (white) holds the imprinter cable loosely.
If the imprinter cable hangs down loosely in the way of the
paper path, use this clamp.
Place the clamp (white) at the left of the upper
2
imprinter shaft.
Connecting Imprinter cable
Fasten the imprinter cable with the clamps (black)
3
as shown in the bottom figure.
Hold the imprinter cable with the clamps (white) if
4
necessary as shown in the bottom cable.
Connect the imprinter cable to the scanner and to
5
the connector of the imprinter.
8
Advertisement
Table of Contents
