Enabling Ports - Dell Force10 S2410-01-10GE-24P Quick Start Manual

Enabling Ports

When the S2410 is first installed, all ports are disabled by default. You can use
the no shutdown command for a specific interface (Interface Config mode). To
enable all ports, enter no shutdown all in Global Config mode.
Setting the IP Address for the Service Port
The S2410 supports the Ethernet Management port (labeled 10/100 Ethernet and
commonly called the service port). It is a dedicated management port (in
addition to the console port and the virtual management port). You can use the
service port to access the switch through Telnet, SSH, TFTP, or the SFTOS Web
UI.
Step Task
Specify the network
1
configuration protocol to be
used (Bootp or DHCP) for
configuring access to the
Ethernet Management port.
Alternatively, leave the default
at none to require the Ethernet
Management port to be
manually configured with IP
information.
If you left the default at none,
2
manually configure the IP
address, IP subnet mask, and
default IP gateway of the
Ethernet Management port.
Verify the service port
3
configuration.
Command Syntax
serviceport protocol {none
| bootp | dhcp}
serviceport ip ipaddr
netmask [gateway]
show serviceport
Installing the Software
Command Mode
Global Config
Global Config
Privileged Exec
19