Fingerprint Reader Board - HP ENVY dv6-7200 Maintenance And Service Manual

Remove the power button board:
1. Turn the top cover upside down, with the front toward you.
2.
Detach the power button board cable (1) from the top cover. (The power button board cable is
attached to the top cover double-sided tape.)
3. Remove the two Phillips PM2.0×4.0 screws (2) that secure the power button board to
the top cover.
4. Remove the power button board (3) and cable.
Reverse this procedure to install the power button board.

Fingerprint reader board

Description
Fingerprint reader board (includes cable and bracket)
Before removing the fingerprint reader board, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the battery (see
a. Hard drive (see
b. Optical drive (see
Battery on page 51), and then remove the following components:
Hard drive on page 52)
Optical drive on page 59)
Component replacement procedures
Spare part number
682062-001
71