Configuring Uplink Management Vlan; Configuring Wired Bridging On Ethernet 0 - Dell PowerConnect W-IAP3WN User Manual

2. Click the edit link. An Edit AP window appears.
3. In the Edit AP window, select the Radio tab.
4. Select Adaptive radio management assigned.
Figure 68
Configuring IAP Radio Settings Mode — Access
5. Click OK.
For more information about ARM, see "Adaptive Radio Management" on page 159.

Configuring Uplink Management VLAN

Instant supports a management VLAN for the uplink traffic on an IAP. After an IAP is provisioned with this
parameter, all management traffic sent from the IAP is tagged with the management VLAN. Perform the
following steps to configure a uplink management VLAN on an IAP:
1. In the Access Points tab, click the IAP.
2. Click the edit link. An Edit AP window appears.
3. In the Edit AP window, select the Uplink tab.
4. Specify the VLAN in the Uplink Management VLAN field.
5. Click OK.
NOTE: This configuration requires an IAP reboot to take effect.

Configuring Wired Bridging on Ethernet 0

Instant supports wired bridging on the Ethernet 0 port of an Instant AP. Perform the following steps to enable
wired bridging on the Ethernet 0 port:
1. In the Access Points tab, click the IAP.
2. Click the edit link. An Edit AP window appears.
3. In the Edit AP window, select the Uplink tab.
4. Select Enable from the Eth0 Bridging drop box.
5. Click OK.
82 | Managing IAPs Dell PowerConnect W-Series Instant Access Point 6.1.3.4-3.1.0.0 | User Guide