Dell PowerConnect W-IAP3WN User Manual page 45




b. Bandwidth Limits— You can specify three types of bandwidth limits.



c. Transmit Rates— Indicates the ability to configure the basic and supported rates per SSID for Dell
Instant. Select to set the minimum and maximum legacy (non-802.11n) transmit rates for each band —
2.4GHz and 5GHz.
d. Miscellaneous




4. Click Next to continue.
Figure 37
Dell PowerConnect W-Series Instant Access Point 6.1.3.4-3.1.0.0 | User Guide
Dynamic multicast optimization— When Enabled, the IAP converts multicast streams into unicast
streams over the wireless link. DMO enhances the quality and reliability of streaming video, while
preserving the bandwidth available to non-video clients.
DMO channel utilization threshold— When dynamic multicast optimization is enabled, the IAP
converts multicast streams into multicast unicast streams as long as the channel utilization does not
exceed this threshold. The default value is 90 and the maximum threshold value is 100%.
If the threshold value exceeds the maximum value, then the IAP sends multicast traffic over the
wireless link.
Airtime— Indicates the aggregate amount of airtime that all clients on this Network can use to send/
receive data.
Each user— Indicates the throughput for any single user on this Network. The throughput value is
specified in kbps.
Each radio— Indicates the aggregate amount of throughput each radio (some AP models have
multiple radios) is allowed to provide for all clients connected to that radio.
Content filtering— When enabled, all DNS requests to non-corporate domains on this wireless
network are sent to OpenDNS.
Band— Set the band at which the network transmits radio signals. Available options are 2.4 GHz, 5
GHz and All. The All option is selected by default. It is also the recommended option.
Inactivity timeout— Indicates the time in seconds after which an idle client ages out. The minimum
value is 60 seconds and the default value is 1000 seconds.
Hide SSID— Select this check box if you do not want the SSID (network name) to be visible to users.
Adding an Employee Network— VLAN Tab
Wireless Network | 45