Dell PowerConnect W-IAP3WN User Manual page 70

Figure 53
Mesh Portal
NOTE: The IAPs in US or JP regulatory domain which are in factory default state scans for several minutes after booting. An IAP
mesh point in factory default state automatically joins the portal if only a single Instant mesh network is found. In addition, the
auto-join feature must be enabled in the existing network.
NOTE: The IAP mesh point will get an IP address from the same DHCP pool as the portal, and this DHCP request goes through the
portal.
70 | Mesh Network Dell PowerConnect W-Series Instant Access Point 6.1.3.4-3.1.0.0 | User Guide