Configuring Sta For Ports - SMC Networks TigerSwitch 100 SMC6924VF Management Manual

Configuring STA for Ports

The following figure and table describe port STA configuration.
Spanning Tree Port Configuration : Unit 1 Port
================================
Fast forwarding on all ports : [Enable]
Port
-----------------------------------------------------
1
2
3
4
5
6
7
8
9
10
11
12
<APPLY> <OK> <CANCEL> <PREV UNIT> <NEXT UNIT> <PREV PAGE> <NEXT PAGE>
Parameter Default
Fast Enabled
forwarding on
all ports
Type
Priority 128
U
SING THE
Type Priority
100FX 128
100FX 128
100FX 128
100FX 128
100FX 128
100FX 128
100FX 128
100FX 128
100FX 128
100FX 128
100FX 128
100FX 128
other keys to make changes.
Description
See "FastForwarding" in this table.
Shows port type as:
100FX
1000SX
1000LX
1000T
Defines the priority for the use of a port in the
STA algorithm. If the path cost for all ports on a
switch are the same, the port with the highest
priority (i.e., lowest value) will be configured as
an active link in the Spanning Tree. Where more
than one port is assigned the highest priority,
the port with lowest numeric identifier will be
enabled. The range is 0 - 255.
S C
YSTEM ONFIGURATION
Cost FastForwarding
19 ENABLED
19 ENABLED
19 ENABLED
19 ENABLED
19 ENABLED
19 ENABLED
19 ENABLED
19 ENABLED
19 ENABLED
19 ENABLED
19 ENABLED
19 ENABLED
: 100BASE-FX
: 1000BASE-SX
: 1000BASE-LX
: 1000BASE-T
P
ROGRAM
1 - 12
[Disable]
2-35