Connecting the VCR
The connection method differs depending on the type of TV.
If you have cable TV (CATV), see Cable TV Connections.
RF Connection (for connection to a TV without AV terminals)
! Disconnect the TV antenna from the TV.
@ Connect the TV antenna cable to the ANTENNA IN terminal on the rear of the VCR.
# Connect the TV OUT terminal on the rear of the VCR with the antenna terminal on the TV using a coaxial
cable. Select the TV channel 3 or 4 corresponding to the 3
Setting the 3
4 Output Channel Selector below.)
AV Connection (for connection to a TV with AV terminals)
! Disconnect the TV antenna from the TV.
@ Connect the antenna, VCR, and TV using the Audio/Video cable and coaxial cable (supplied) as shown.
# Select the video input mode or A/V input mode on your TV. (See the TV operation manual for details.)
• If your VCR is a monaural model, connect the audio cable to "AUDIO OUT" on the VCR.
VCR Rear
(Hi-Fi model)
After the Connection
Plug in the power cord of the TV. Then go to EZ Set Up.
Setting the 3
The 3
4 OUTPUT CHANNEL selector changes the VCR OUTPUT to standard
TV broadcasting signals. Both your TV and VCR must be set to the same
channel (i.e. TV on channel 3 and VCR OUTPUT CHANNEL selector on 3).
Your VCR is set to channel 3 at the factory, so your TV should be tuned to
channel 3 as well. If channel 3 is an active broadcast channel in your area, set
the VCR 3
4 OUTPUT CHANNEL selector to 4 and tune your TV to channel 4.
Connect the flat twin lead cable
TV
4 Output Channel Selector
4 output channel selector of the VCR. (See
to a transformer
(300 ohm to 75 ohm, not
supplied)
Audio/Video
cable (not
supplied)
Coaxial cable (supplied)
Antenna
Coaxial cable
ANTENNA IN
(antenna or
cable
input)
TV OUT
Rear of Your VCR
3
4 OUTPUT CHANNEL
selector
9