Sharp VC-A410U Operation Manual page 30

D A T E C H
8 / 1 0 0 7
- - / - - - - -
- - / - - - - -
- - / - - - - -
T U R N V C R P O W E R O F F
F O R T I M E R R E C O R D I N G .
POWER TIMER
• If the power is interrupted for more than 5 seconds (power failure, etc.) during timer recording, the Auto Clock Setting will
reset the time after the power is returned (the POWER LED indicator will flash) but the timer settings will be cancelled.
• Numbered buttons can be used instead of ∂/ƒ to set the data.
• If the cassette ends before recording all the programs, the VCR will stop, eject the cassette and turn the power off
automatically.
• In Step (, if POWER is pressed with no cassette inserted, the TIMER LED indicator flashes for 5 seconds indicating that
timer recording is not possible.
• In Step (, if the inserted cassette is without the erasure protection tab, TIMER LED indicator flashes and the cassette is
ejected.
• To stop timer recording, press STOP.
• If a button is not pressed within 3 minutes during the setting procedure, the screen will return to the normal screen.
• There are two timer setting screens (1/2, 2/2).
30
& Press SET.
1 / 2
S T A R T S T O P
9 : 0 5 PM 1 0 : 3 5 PM S P
- : - - - : - - - -
- : - - - : - - - -
- : - - - : - - - -
* Press MENU to finish settings.
Normal
Screen
( Press POWER to enter the timer standby mode. Be sure
VCR REC
• To program the additional timer settings, press SET and
repeat steps @–&.
The display shown to the left appears on the screen for 5
seconds, after which the normal screen returns.
that the TIMER LED indicator light up.
Recording with the Timer