Setting The Channels - Sharp VC-A410U Operation Manual

Setting the Channels

Your VCR can receive a maximum of 181 channels as shown below by presetting the channels into memory.
(VHF: 2 to 13, UHF: 14 to 69, CATV: 1 to 125)
• Make sure that the cable (antenna or CATV) is connected to the IN terminal on the rear of the VCR.
T I M E R
∂
S E T U P
C H A N N E L P R E S E T
C L O C K
L A N G U A G E
ƒ
S E L E C T :
E N T E R : S E T
C H A N N E L P R E S E T
ß
A I R / C A T V
C H A N N E L P R E S E T
©
C H S E T
A I R / C A T V
ß
C H S E T
©
A U T O M A T I C T U N I N G .
P L E A S E W A I T .
• Automatic tuning will not start unless the arrow is at "CH SET-AUTO" position.
• If a button is not pressed within 3 minutes during the setting procedure, the screen will return to normal.
• If the power is interrupted for more than 5 seconds, AIR/CATV selection must be set again.
• Automatic tuning will be interrupted if PLAY, REC or MENU buttons are pressed before the screen returns to normal.
M E N U
E X I T : M E N U
A I R C A T V
ƒ
A U T O M A N U A L
A I R C A T V
A U T O M A N U A L
0 2
Normal
Screen
! Press MENU.
Select "CHANNEL PRESET" with ∂/ ƒ and then press
SET.
@ Select "AIR" or "CATV" with ß /© and then press ƒ.
Ex.: AIR
• To watch cable TV after EZ Set Up, select "CATV",
press SET.
# Set "CH SET" to "AUTO" with ß /© and then press SET.
$ The auto tuning will start.
The channel display will count up and when finished, the
screen returns to normal.
19