Tape Dubbing Connection Instructions - Sharp VC-A410U Operation Manual

Tape Dubbing Connection Instructions

Your VCR can dub (copy) video material from another video device. It can also output video and audio signals
for recording on other video or audio equipment. Audio/Video dubbing cannot be done separately.
! Switch your VCR to the auxiliary input by pressing INPUT on the remote control. (You can also use
CHANNEL ∂/ƒ on the VCR or CH ∂/ƒ on the remote control.)
@ Begin recording on the dubbing VCR and playback on the source VCR simultaneously.
• When using special playback functions (still picture, video search, frame advance and variable slow motion) during
dubbing, a blue screen may appear.
Set BLUE SCREEN mode on the dubbing VCR (for recording) to OFF. (See Mode Selection.)
• To use the TV as a monitor while dubbing, press TV/VCR to "VCR" on the dubbing VCR.
• Use an RCA pin-type connection cable (not supplied with VCR, but supplied with VIEWCAM) to connect source VCR to
dubbing VCR.
• Refer to the manual of the VCR connected to this unit when dubbing a tape.
Only for Hi-Fi models
• If source VCR is a monaural mode, connect the audio cable to "AUDIO-L" of the dubbing VCR.
(VC-A410U, VC-A411U, VC-A420U)
Source VCR
(for playback)
Audio/Video cable
(not supplied)
Dubbing VCR
(for recording)
Coaxial cable
(supplied)
Sharp Viewcam
(for playback)
Audio/Video
cable (supplied
with Viewcam)
or
To Front
(Only for VC-A420U)
TV Rear
ANT/CABLE
(VC-H810U, VC-H811U, VC-H820U)
Source VCR
(for playback)
Audio/Video cable
(not supplied)
Dubbing VCR
(for recording)
Recording a TV Program
Sharp Viewcam
(for playback)
Audio/Video
cable (supplied
with Viewcam)
or
To Front
(Only for VC-H820U)
TV Rear
Coaxial cable
(supplied) ANT/CABLE
27