Auto Sync. Adjustment (Pc Input Mode Only); Fine Sync. Adjustment (Pc Input Mode Only) - Sharp LC-30AD1E Operation Manual

Useful adjustment settings
Auto Sync. adjustment (PC input
mode only)
For automatically adjusting the PC image.
1
Press MENU and the MENU screen displays.
2
Press c/d to select "Setup".
• Setup menu displays.
3
Press a/b to select "Auto Sync.", and then
press OK.
4
Press c/d to select "Yes", and then press
OK.
• Auto Sync. starts and "Adjusting the image"
displays.
[Setup ... Auto Sync.]
MENU
Yes
NOTE
• When Auto Sync. is successful, "Auto Sync completed
successfully" displays. If not, Auto Sync. failed.
• Auto Sync. may fail even if "Auto Sync completed
successfully" displays.
• Auto Sync. is likely to succeed when an input PC image
has wide vertical stripes (ex. pattern with high contrast
stripes, or cross-hatched).
It may fail when an input PC image is solid (low contrast).
• Be sure to connect the PC to the AVC System and switch
it on before starting Auto Sync.
72
LC-30AD1E(E)-h
No
30%
72
Fine Sync. adjustment (PC input
mode only)
Ordinarily you can easily adjust the picture as
necessary to change image position using Auto Sync.
In some cases, however, manual adjustment is needed
to optimise the image.
1
Press MENU and the MENU screen displays.
2
Press c/d to select "Setup".
3
Press a/b to select "Fine Sync.", and then
press OK.
4
Press a/b to select the specific
adjustment item.
H-Pos. [90] –
V-Pos. [39] –
Clock [90] –
Phase [20] –
Reset
5
Press c/d to adjust the item to your
desired position.
NOTE
• For resetting all adjustment items to the factory preset
values, press a/b to select "Reset", and then press OK.
Selected item Description
Centres the image by moving it to the left or
H-Pos.
right.
Centres the image by moving it to the up or
V-Pos.
down.
Clock
Adjusts the clock frequency.
Adjusts the clock phase.
Phase
03.10.31, 1:26 PM
+
+
+
+