Watching A Decoder Image; Connecting A Decoder; Displaying A Programme - Sharp LC-30AD1E Operation Manual

Using external equipment

Watching a decoder image

Connecting a decoder

You can use the INPUT 1 terminal when connecting a decoder and other audiovisual equipment.
INPUT SOURCE
TV
DTV
PC
MENU [ Option ... Input Select ]
CVBS
(For INPUT1 signal)
LC-30AD1E(E)-g
AVC System (rear view)
SCART cable
(commercially available)
INPUT1
INPUT2
INPUT3
INPUT4
RGB
63

Displaying a programme

To watch a decoder image, select "INPUT1" from the
"INPUT SOURCE" menu using b on the remote
control unit or INPUT on the Display.
The setting is stored and can be selected in the "INPUT
SOURCE" menu.
NOTE
• Each time b is pressed, the input source toggles.
• If the decoder image does not come in clearly, you may
need to change the input signal type setting on the "Input
Select" menu.
• It is recommended to connect to the INPUT 1 terminal
when using a decoder for ground wave signal input. If
INPUT1 signals are preset in auto installation or
programme setup, make sure to set "Decoder" to
"INPUT1" in the Programme Setup "Manual" menu. (See
page 32.)
• Refer to your decoder operation manual for the signal type.
• See page 73 for how to select the signal type.
03.10.31, 1:25 PM
Decoder
63