Watching A Decoder Image; Connecting A Decoder; Displaying A Programme - Sharp AQUOS LC-37HV4E Operation Manual

Using external equipment

Watching a decoder image

Connecting a decoder

You can use the INPUT 1 terminal when connecting a decoder and other audiovisual equipment.
AVC System (rear view)
INPUT SOURCE
TV
INPUT1
INPUT2
INPUT3
INPUT4
PC
TV MENU
Option
Input Select
CVBS
(For INPUT1 signal)
SCART cable
(commercially available)

Displaying a programme

To watch a decoder image, select "INPUT1" from the
"INPUT SOURCE" menu using b on the remote
control unit or INPUT on the Display.
Then select "INPUT1" on "Input Select" in the "Option"
menu to set the correct input signal type. (See page
52.)
The setting is stored and can be selected in the "INPUT
SOURCE" menu.
• Each time b is pressed, the input source toggles.
• If the decoder image does not come in clearly, you may
• It is recommended to connect to the INPUT 1 terminal
• Refer to your decoder operation manual for the signal type.
RGB
NOTE
need to change the input signal type setting on the "Input
Select" menu.
when using a decoder for ground wave signal input. If
INPUT1 signals are preset in auto installation or
programme setup, make sure to set "Decoder" to
"INPUT1" in the Programme Setup "Manual" menu. (See
page 28.)
Decoder
41