High Limit - Frymaster GEN II LOVTM BIELA14 Operator's Manual

Problem
M3000 display shows
hot-hi-1.
M3000 display shows
hELP HI-2 or

High limit

failure.
M3000 display shows
TEMP PROBE
FAILURE.
M3000 display shows
HEATING
FAILURE.
Heating indicator is
on, but fryer is not
heating.
M3000 display shows
RECOVERY
FAULT and alarm
sounds.
M3000 display shows
REMOVE
DISCARD.
Computer locks up.
M3000 displays
SERVICE
REQUIRED followed
by an error message.
7.2.3 Filtration Problems
Problem
Fryer filters after each
cook cycle.
MAINT FILTER
(Manual Filter) won't
start.
Filter pump won't
start or pump stops
during filtering.
Probable Causes
Frypot temperature is more than 410ºF
(210ºC) or, in CE countries, 395ºF
(202ºC).
Failed high limit
Problem with the temperature
measuring circuitry including the probe
or damaged computer wiring harness or
connector.
Failed computer, failed interface board,
open high-limit thermostat.
Three phase power cord unplugged or
circuit breaker is tripped.
Recovery time exceeded maximum time
limit.
A product cook is started that has a
different setpoint than the current vat
temperature.
Computer error.
An error has occurred which requires a
service technician.
Probable Causes
Filter after setting incorrect.
Temperature too low.
A. Power cord is not plugged in or
circuit breaker is tripped.
Corrective Action
Shut the fryer down immediately and
call your ASA for assistance.
Shut the fryer down immediately and
call your ASA for assistance.
Shut the fryer down and call your ASA
for assistance.
Call your ASA for assistance.
Verify that both the main power cord and
120V is fully seated in its receptacle,
locked into place and that circuit breaker
is not tripped If the problem continues
call your ASA for assistance.
Clear error and silence the alarm by
pressing the
recovery time for electric is 1:40. If this
error continues call your ASA for
assistance.
Remove and discard product. Press the
cook button under the display with the
error to remove the error.
setpoint of the vat before trying to cook
product.
Call your ASA for assistance.
Press (2 NO) to continue cooking and
call your ASA for assistance. In some
cases, cooking may not be available.
Corrective Action
Change or overwrite the filter after
setting by re-entering the filter after
value in level two. See section 4.13.5
on page 4-33.
Ensure fryer is at setpoint before
starting MAINT FILTER.
A. Verify that the power cord is fully
plugged in and the circuit breaker
is not tripped.
7-3
button. Maximum
Reset the