Frymaster GEN II LOVTM BIELA14 Operator's Manual page 58

3. Then in reverse order, place the metal filter screen in the center of the bottom of the pan, then lay
a filter pad over the screen, ensuring that the rough side of the pad is up. Make sure that the pad
is in between the embossed ridges of the filter pan. Then position the hold down ring on top of
the pad. If using filter paper, lay a sheet of filter paper over the top of the pan overlapping on all
sides. Position the hold down ring over the filter paper and lower the ring into the pan, allowing
the paper to fold up and around the ring as it is pushed to the bottom of the pan. Then sprinkle 1
packet (8-ounces) of filter powder over the filter paper.
4. Reinstall the crumb tray at the front of the pan. (See Figure 1)
DO NOT USE FILTER POWDER WITH THE PAD!
5. Push the filter pan back into the fryer, positioning it under the fryer. Ensure "A" is displayed on
the MIB board. The filtration system is now ready for use.
Do not drain more than one frypot at a time into the built-in filtration unit to avoid
overflow and spillage of hot oil that may cause severe burns, slipping and falling.
The crumb tray in fryers equipped with a filter system must be emptied into a
fireproof container at the end of frying operations each day. Some food particles can
spontaneously combust if left soaking in certain shortening material.
Do not bang fry baskets or other utensils on the fryer's joiner strip. The strip is
present to seal the joint between the fry vessels. Banging fry baskets on the strip to
dislodge shortening will distort the strip, adversely affecting its fit. It is designed for
a tight fit and should only be removed for cleaning.
5.3 Auto Intermittent Filtration (AIF)
Auto Intermittent Filtration (AIF) is a feature that, after a number of preset cook cycles or time, will
automatically filter frypots.
An M3000 computer controls the Auto Intermittent Filtration
(AIF) system on the LOV™ fryer. After a preset number of cook
cycles or time the computer displays FIltEr now?
alternating with YES NO.
simultaneously. The LED will turn off once a filtration cycle is
NO
started. If is selected or a cook cycle is started, the blue LED
will go off and will prompt again soon to filter the oil.
YES
(1)
1. Press
filtration.
WARNING
The blue LED is activated
to start filtration and
DANGER
DANGER
NO
(2)
to cancel
5-2