Frymaster GEN II LOVTM BIELA14 Operator's Manual page 63

5.4.5 Filter Busy
When FILTER BUSY is displayed the MIB board is waiting on another vat to be filtered or
waiting on another issue to clear. Wait 15 minutes to see if problem is corrected. If not, call your
local ASA.
Do not drain more than one frypot at a time into the built-in filtration unit to avoid
overflow and spillage of hot oil that may cause severe burns, slipping and falling.
The filter pump is equipped with a manual reset switch in case the filter motor
overheats or an electrical fault occurs. If this switch trips, turn off power to the filter
system and allow the pump motor to cool 20 minutes before attempting to reset the
switch (see photo below).
Use caution and wear appropriate safety equipment when resetting the filter pump
reset switch. Resetting the switch must be accomplished with care to avoid the
possibility of a serious burn from careless maneuvering around the drain tube and
frypot.
5.5 Manual or End of Day Filtration (MAINT FLTR)
Do not drain more than one frypot at a time into the built-in filtration unit to avoid
overflow and spillage of hot oil that may cause severe burns, slipping and falling.
Ensure that the filter pad or paper is replaced daily to keep the system operating correctly.
1. The fryer MUST be at setpoint temperature.
With the computer ON press and hold the
FLTR button for three seconds.
Filter Pump Reset Switch
NOTICE
The filter pad or paper must be replaced daily.
DANGER
WARNING
WARNING
DANGER
5-7