Frymaster GEN II LOVTM BIELA14 Operator's Manual page 25

4.7 M3000 Button Description and Functions
4.7.1 Navigation Buttons
34 tu
The menu on the M3000 uses and buttons to
navigate the various menus and submenus.
When programming, the left screen shows a menu or
submenu item. The right screen is for data entry. Data is
Left Display Right Display
entered with alpha-numeric characters, scrolling through
lists or by toggling between choices.
During programming if a button is not pushed within one minute, the computer returns to operation
mode.
4.7.2 Filter, Temperature and Info Buttons
< FLTR FLTR >
The and buttons (see Figure 1) are used to filter the left and right vats of a split
FLTR
vat or a full vat fryer on demand. The buttons, if pressed once displays the number of cook
FLTR
cycles remaining until a filtration prompt. When the button is pressed twice, the date and
TEMP
time of the last filter is displayed. The button, if pressed once while the fryer is on,
TEMP
displays current vat temperature on both sides. If the button is pressed twice while the fryer
is on, it shows the setpoint temperatures of the vats. If the fryer is off, the display shows the current
INFO
versions of software. The button (see Figure 1), if pressed once when the fryer is on, shows
the recovery time for each vat from the last test. Recovery is the time required for the fryer to raise
the temperature of the oil 50°F (28°C) between 250°F (121°C) and 300°F (149°C). Maximum
INFO
recovery time should not exceed 1:40 for electric or 2:25 for gas. If the button is pressed and
held for three seconds it shows information such as usage, filter statistics and last cook cycles (see
INFO
page 4-34 for more details on the button).
4.7.3 Cook Channel and Selection Buttons
The buttons are dual-function buttons shared with
1 2
the number and buttons. They are located directly
below the LED displays. Use these buttons to select or
cancel functions. The button is used to back out of and
exit submenus.
4-7