Frymaster FOOTPRINT 8195991 Installation And Operation Manual page 46

PROBLEM
Heating mode light
cycles on and off
normally. Blower
not running and
burners will not
ignite.
Fryer is slow coming
out of melt cycle.
Heating mode light
is ON. Trouble light
comes on a short
time after coming
out of melt cycle.
Fryer is operating
normally, but
recovery is slow
when cooking.
Fryer is operating
normally, but
produces popping
sound when burners
ignite.
Heating mode light
is on and blower is
running, but burner
will not ignite.
Heating mode light
is cycling on and off
normally and fryer
is operating
normally, but
trouble light is on
continuously (false
alarm).
PROBABLE CAUSES
A. Failed controller.
B. Damaged controller wiring
harness.
Dirty or obstructed combustion air
blower.
Dirty or obstructed combustion air
blower.
A. Obstructed combustion air
blower.
B. Dirty or obstructed gas valve vent
tube (non-CE fryers only).
C. Malfunctioning combustion air
blower.
Blown fuse on interface board or
ignition module.
A. Failed controller.
B. Damaged controller wiring
harness.
CORRECTIVE ACTION
A. If available, substitute a controller
known to be working for the
suspect controller. If the fryer
functions correctly, order
replacement from FASC.
B. If available, substitute a harness
known to be good for the suspect
harness. If the fryer functions
correctly, order replacement
harness from FASC.
Clean and adjust per instructions
in Chapter 5 of this manual.
Clean and adjust per instructions
in Chapter 5 of this manual.
A. Clean and adjust per instructions
in Chapter 5 of this manual.
B. Clean per instructions in Chapter
5 of this manual.
C. If blower is slow to come up to
speed, contact FASC for service.
Replace fuse.
A. If available, substitute a controller
known to be working for the
suspect controller. If the fryer
functions correctly, order
replacement from FASC.
B. If available, substitute a harness
known to be good for the suspect
harness. If the fryer functions
correctly, order replacement
harness from FASC.
6-5