Replacing The Controller (17Ec/17Ecs And Ewbs With Cm Iii Computer) - Frymaster 17EC Installation, Operation & Service Parts Manual

PROBLEM
Autoskim does not
add water (Autofill
operating correctly)
Basket Lift does not
function correctly.
5.3

Replacing the Controller (17EC/17ECS and EWBS with CM III Computer)

1. Disconnect the cooker from the electrical supply.
2. Remove the two screws in the upper corners of the control panel and swing the panel open
from the top, allowing it to rest on its hinge tabs.
3. Disconnect the wiring harness from the back of the controller.
4. Disconnect the ground wire from the controller. Remove the controller by lifting it from the
hinge slots in the frame.
5. Reverse the procedure to install a new controller.
Troubleshooting Guide (Continued)
PROBABLE CAUSES
Defective controller.
A. Blown fuse (17EC and
17ECS models only).
B. Roller jammed.
C. Lifter rod jammed.
D. Defective controller.
E. Loose or misadjusted
microswitch.
Wiring Harness
Connection
Ground Wire
5-3
CORRECTIVE ACTION
Replace controller (see Section 5.3).
A. Replace fuse (see Section 5.4)
B. Adjust roller.
C. Check for free movement.
Lubricate with white grease.
D. Replace controller (see Section
5.3).
E. Check switch adjustment. Adjust
as required.