Accessing Equipment For Servicing; Replacing Equipment Components; Replacing Electronic Components - Frymaster Pasta Magic Service Manual

A thermostat monitors the temperature in the cookpot. When the setpoint temperature is reached,
the contacts open, which de-energizes the 24VAC heat relay, thus cutting line voltage to the blower
and the 24VAC to the ignition module.
1.2

Accessing Equipment for Servicing

Moving this equipment while it is filled with hot water may cause spilling or
splattering of the hot water. Always drain the cookpot before attempting to relocate
1. Disconnect the unit from the electrical power supply, the gas supply and the water supply.
2. Disconnect any attached restraining devices.
3. Relocate the unit for service accessibility.
4. After servicing is complete, reconnect the unit to the water supply and the gas supply. Reattach
the restraining devices, and reconnect the unit to the electrical power supply.
1.3

Replacing Equipment Components

1.3.1 Replacing Electronic Components

1. Drain the cookpot and disconnect the cooker form the electrical power supply.
2. The control box is mounted inside the bottom of the cabinet located beneath the cookpot. It may
be easier to remove the control box to replace components. The box is secured with two screws
on the front bottom bracket of the box.
Screws
securing
control box
3. On the component to be replaced, make a note of the wiring connection points. Disconnect the
wires and remove the failed component. Install the replacement component and reconnect the
wiring in accordance with the notes made, or with the wiring diagram on the door of the unit.
4. Replace the component box cover, and reinstall the controller being sure to reconnect the ground
wire and trouble light wires. Reconnect the cooker to the electrical power supply.
DANGER
this equipment for servicing.
24VAC Heat
Relay
Transformer
1-3
Fenwal
Ignition
Module