Error Messages And Error Codes; Error Messages (In Alphabetical Order) - Xerox DocuPrint 3055 User Manual

6.6

Error Messages and Error Codes

Error Messages (in Alphabetical Order)

The following table lists the error messages that appear on the control panel.
Note
• When a message cannot be displayed in one screen, the display switches between two or three screens
to display the entire message. The
display.
Message
Clear Jam from
Bypass Tray or
Open A
Clear Jam
Close A & C
Close D
Disk is full
Press SET
and Cancel JOB
Install
Toner Cartridge
Invalid job
Press SET
and Cancel JOB
Invalid feature
Press SET
and Cancel JOB
Limit reached
Press SET
and Cancel JOB
Load in Bypass
xx xx xxxx
in the following table indicates the screen switching motion of the
A paper jam occurred in the printer.
Remove the jammed paper from the bypass tray. Then, open the front cover. If you
see the jammed paper, remove it from the printer.
Refer to
• "6.1 Clearing Paper Jams" (P. 133)
The front cover or top cover is open.
Close the cover.
Refer to
• "2.1 Main Components and Functions" (P. 34)
The inner cover is open.
Close the inner cover.
Refer to
"2.1 Main Components and Functions" (P. 34)
The hard disk (optional) is full.
Cancel the print job by pressing the <Eject/Set> button on the control panel.
Increase the hard disk space by deleting the files that are unnecessary.
A print cartridge is not installed.
Install a print cartridge appropriate for the printer.
Refer to
• "Replacing the Print Cartridge" (P. 160)
• "Type of Consumable" (P. 158)
The job was not printed since the request is not valid.
This message may appear when the accessory configuration settings differ from the
actual configuration (for example, you requested 2-sided printing when the duplex
unit is not installed, but it is set to [Available] on the print driver).
Cancel the job by pressing the <Eject/Set> button on the control panel.
Correctly specify the print request and try printing again.
If the Authentication feature is used, you are not registered as a user who is
authorized to print. Cancel the job by pressing the <Eject/Set> button on the control
panel.
For information about the user registration, consult your system administrator.
The number of pages permitted to print that is set on the [Print Auditron] on
CentreWare Internet Services has reached the maximum.
Cancel the job by pressing the <Eject/Set> button on the control panel.
For information about the Print Auditron, consult your system administrator.
The size of the paper loaded in the bypass tray does not match the paper size
specified by the job.
Load the paper indicated in the message (xx xx xxxx) in the bypass tray.
Refer to
• "Loading Paper in the Bypass Tray" (P. 83)
Symptom/Cause/Remedy
6.6 Error Messages and Error Codes
149