Xerox DocuMate 4440 User Manual page 136

3. Click the Properties button.
• Enable power save mode—Power save mode is the low-power state when the scanner is not
in use. Click the up arrow to increase the time before the scanner goes into the low-power
state after the last use. Or, click the down arrow to decrease the time before the scanner goes
into the low-power state after the last use. This setting has a range of 1 minute to 3 hours.
• Lamp On and Lamp Off—click the Lamp On or Lamp Off buttons to immediately turn the
scanner lamp on or off.
• Reset Device—click the Reset Device button reset the power saving options back to the
defaults.
4. Click OK to save the changes and close the dialog box.
136 Xerox DocuMate 4440
User's Guide