A-K5L Keypad Update Port And Jumpers; A-K5L Keypad Rear Panel; A-K5L Keypad Installation - Russound A-C68 Installation Manual

Keypad Connections
SPEAKER OUTPUT - Speaker
output connections for a pair of
8-ohm speakers. 4-pole screw down
terminals accept up to 14 gauge
speaker wire.
RJ45 HUB CONNECTOR - 8-conductor
RJ45 connector for the CAT-5
connection from the keypad to the
hub/controller.
VARIABLE LINE LEVEL OUTPUT
- Line-level audio output connection
for external amplifier or powered
subwoofer. 4-pole screw-down
terminal accepts a stripped
two-conductor RCA cable.
HUB
Keypad Installation
1. Ensure it is possible to route the
wire to the desired location.
2. To install a single-gang keypad,
use a UL/CSA approved plastic
single-gang (18 ci) electrical box.
3. Route CAT-5 wire to the electrical
box from the A-C68 system
controller and connect to keypad
via RJ45 connector.
4. Route speaker wire from room
speakers to keypad. connect to
screw-down terminal.
5. Mount the keypad in the
electrical box and attach the trim
plate.
Russound A-C68 Installation Manual
A-K5L KEYPAD CONNECTIONS / INSTALLATION
Keypad Update Jumper
OS UPDATE/RUN JUMPER - (located on
the back circuit board, left side) The
pins are jumpered when performing
a firmware update. with jumper
removed during normal use.
OS UPDATE PORT - Used to update
the A-K5L keypad operating system
firmware. Uses the Russound Advanced
Programming Cable,
Part #2500-521065.
Keypad Status Jumper
STATUS LED JUMPER - Both pins
jumpered, Status LED enabled. One or
no pins jumpered, Status LED disabled
SETUP BUTTON - Activates Installer
Setup mode and accesses update
menus
13