Russound A-C68 Installation Manual page 24

PROGRAMMING CENTER
The A-C68 sources are configured through the Programming Center, located
on the front of the A-C68 behind the removable lower panel. The LEDs are dual
purpose with different colors to indicate different modes.
NOTE: To remove cover panel, press in right and left tab at the cover's bottom
edge, then lift out and up.
The A-C68 has two main programming modes: Controller Setup Mode and
Source Setup Mode. The functions used in Controller Setup Mode (Ctrl ID and
Fact Init) are accessed with a press and HOLD of the Setup button. The functions
Indicator LEDs turn on/off and blink slow/fast to indicate
setup process steps and to indicate when to enter
information via the A-SRC1
24
used in Source Setup Mode (Source/Test, Cmd/Type, Code/Key and IR Learn)
are accessed with a press and RELEASE of the Setup button.
The A-SRC1 system remote control is used to enter information during the
setup procedures, and the LEDs show solid, blinking or off to indicate what is
being programmed and when to enter information.
To exit either setup mode, press the Setup button until no LEDs are illuminated
in the Programming Center.
1 2 3 4 5 6 7 8
Russound A-C68 Installation Manual
A-SRC1 Remote Control is aimed at
IR In on A-C68 during setup