Speaker Connections - Russound A-C68 Installation Manual

KEYPAD TO SPEAKER CONNECTION
The speakers in each room are connected to the A-BUS keypad using 4-pole
screw down terminals.
NOTE: An 8 Ohm minimum speaker is required for each amplified output.
1. Pull the speaker wire conductors apart so they're separated for the first two
inches from their ends.
2. Using a wire stripper, remove 1/4 inch of insulation from each conductor.
Twist the strands in each conductor into tight spirals.
Screw down speaker
cable connector
NOTE: Use
caution when
connecting speaker
wires, as shorting
between terminals
will cause damage
to the digital
amplifier and void
the warranty.
18
3. Insert the speaker wire conductor into the appropriate Speaker Out screw-
down terminal opening, matching channel and polarity for all four wires.
Tighten the connection for each conductor.
NOTE: Use caution when connecting speaker wires, as shorting between
terminals will cause damage to the digital amplifier and void the warranty.
HUB
Speaker cable
A-K5L (back)
Russound A-C68 Installation Manual
8-ohm speakers