Projector Connection Settings; Network Connections Using The Configuration Menus - Epson EMP-7800 User Manual

Projector Monitoring and Control using a Network Projector Monitoring and Control using a Network

Projector Connection Settings

When the projector is connected to the network, various settings such as
the IP address must be made using the configuration menus before the
projector can be used.

Network connections using the configuration menus

Use the accessory remote control to carry out these operations.
PROCEDURE
Press the [Menu] button on the remote control and
1
then select "Network" from the "Advanced2" menu.
Refer to "Using the Configuration Menus" (
on using the menus.
Press the [Num] button on the remote control to enter
2
numbers.
You may need to enter numbers as part of the settings for an
item. If you press the [Num] button, it will light up and the
remote control buttons shown right can be used as a numeric
keypad.
Press the [Num] button again to cancel the numeric keypad
mode.
p.92) for details
The following table shows the setting details for each item.
DHCP
IP Address
Subnet Mask
Gateway
Address
Remote control
Numeric buttons
The buttons inside the box will switch
to numeric keypad mode while the
[Num] button is lit.
Sets whether DHCP is used or not.
ON: DHCP is used.
OFF: DHCP is not used.
Settings can be entered when "DHCP" is set to "OFF".
Enter the IP address that has been assigned to the
projector.
Settings can be entered when "DHCP" is set to "OFF".
Enter the subnet mask that has been assigned to the
projector.
Settings can be entered when "DHCP" is set to "OFF".
Enter the IP address for the gateway that has been
assigned to the projector.
97