Turning The Projector Off - Epson EMP-7800 User Manual

Turning the Projector Off

Follow the procedure below to turn the projector off.
PROCEDURE
Turn the power off for the signal sources that are
1
connected to the projector.
Check that the power for all connected components has been
turned off.
Press the [Power] button on either the remote control
2
or the projector's control panel.
Remote control
The following confirmation message will appear.
Power OFF?
Yes : Press
No : Press any other button
If you do not want to turn the power off, press a button other
than any of the following:
• At the remote control: [Power], [ ], [ ], [ ], [Num], [ID]
• At the control panel : [Power]
If you do not press any button, the message will disappear
automatically after seven seconds. (The power will not turn off
at this time.)
button
TIP
If the message "The projector is overheated. Clean or replace the air
filter and lower the room temperature." appears on the screen, press
the [Enter] button on the remote control or the [Auto/Enter] button on
the projector's control panel to turn the power off and then clean the
air filters. p.124
Press the [Power] button on either the remote control
3
or the projector's control panel once more.
The lamp will switch off. The
cool-down will start.
The cool-down period lasts for about 30 seconds.
When cool-down is complete, the
Stops flashing and lights orange
TIP
The remote control and projector's control panel buttons cannot be
operated while the indicator is flashing orange. Wait until it lights
constantly.
38
indicator will flash orange and
indicator lights orange.