Advanced2" Menu - Epson EMP-7800 User Manual

Hide thumbs Also See for EMP-7800:
Table of Contents

Advertisement

Using the Configuration Menu Functions
Using the Configuration Menu Functions

"Advanced2" Menu

Video
Brightness Control
Audio
Projector ID
Effect
Network
Setting
COM Port
User's Logo
Auto Setup
Advanced1
BNC Sync Termination
Advanced2
Reset
About
Reset All
[
]: Select
[
]: Enter
Sub-menu
Brightness
Control
:
High
Low
: 1
Set
Set
:
RS-232C
USB
:
ON OFF
:
ON OFF
Execute
Projector
ID
Network
[Menu]: Exit
COM Port This can be set to either "RS-232C" or "USB" depending on
Auto Setup Selects whether the automatic adjustment function for
BNC Sync
Termination
Function
This lets you set the lamp brightness to one of two settings.
Select "Low" if the images being projected are too bright
such as when projecting images in a dark room or onto a
small screen.
When "Low" is selected, the brightness of the images is
reduced, but the amount of electricity consumed and noise
produced during projection are reduced and the lamp's
operating life is extended.
Sets the ID number for the projector.
Sets the
DHCP
,
IP Address
,
Subnet Mask
Gateway
Address when the projector is connected to a
network and the EMP Monitor function or mail notification
function are being used. It also lets you set the IP address
for a computer to use for notification of problems when
using
SNMP
for network monitoring.
the port that is being used for communication with a
computer.
When this setting is changed, turn the power off, and when
the
cool-down
period has finished, turn the power back on
again. The new setting will be applied after the power is
turned back on.
automatically optimising images when the input source is
switched to computer analogue images.
Sets the termination mode for the [BNC] port. This is used
for image terminal processing.
•ON : Analogue (75 Ω) termination
•OFF: TTL (Normal signal level output by the computer)
input
This should normally be set to "OFF". If an analogue (75
Ω) termination such as for a switcher is required, change
the setting to "ON".
Default
High
p.71
1
and
-
p.97
RS-232C
ON
OFF
88

Advertisement

Table of Contents
loading

Table of Contents