Table of Contents
Advertisement
•
Reson
sets the filter resonance for all bands.
•
Spread:
Frequency spacing between bands in semitones.
•
Ultra
adds a second filter stage with high resonance, resulting in a steeper slope and a
more "liquid" sound.
•
Stereo Band:
stereo weighting; a value of "1" will leave all bands of both channels at
unity gain, settings <1 will lower the level of odd numbered bands in the left channel
and of even numbered bands in the right channel, settings >1 will do the opposite.
Band #1 will always remain at unity gain to keep the stereo image somewhat stable.
•
Lbal
crossfades Band 1 output between BPF and LPF (0 = BPF, 1 = LPF)
•
Hbal
crossfades Band 5 output between BPF and HPF (0 = BPF, 1 = HPF)
5.4.2 Satur8 Controls
•
In Gain:
Input gain into the Saturation circuit. Higher values give more saturation. Unit
is dB.
•
Out Gain:
Output gain of the Saturation circuit.
5.4.3 Frequency Modulation Controls
•
Frq Mod
controls the filter array center frequency modulation amount; unit is semi
tones.
•
LFO-ENV
blends the modulation source from pure LFO modulation (=0) via 50/50 mix
(= 0.5) to pure Envelope Follower modulation (= 1).
•
LFODly
delays the LFO signal used to modulate the filter array center frequency; unit is
16th notes.
•
LFO Wide:
During "On" state, the LFO signal is inverted for the right channel, resulting
in the modulation going in opposite directions for the left and right channels.
•
ENV Inv:
During "On" state, the Envelope Follower signal is inverted and normalised;
this means that instead of going from 0...1, the envelope will go from 1...0.
•
EnvDly
delays the Envelope Follower signal used to modulate the filter array center fre
quencies; unit is 16th notes.
5.4.4 Spread Modulation Controls
•
Sprd Mod
controls the Frequency Spread modulation amount; unit is semitones.
The Ensembles
Spreadbands
DEEP FREQ - Manual - 38
Advertisement
Table of Contents
