Spreadbands (Filter) Controls - Native Instruments Deep Freq Manual

Table of Contents

The Ensembles

Spreadbands

Fig. 5.6 Spreadbands control page.

The SSFX Spreadbands circuit consists of five parallel filters in Bandpass mode. Their fre

quencies are defined via the center frequency of the middle band and the "Spread" param

eter, which sets the distance between adjacent bands in semitones. Thus a Spread of "12"

will result in the filters being spaced one octave apart. The lowest and highest bands can

be crossfaded from Bandpass to Lowpass and Highpass, respectively. An Envelope Follow

er and an LFO can be used to modulate Center Frequency and Spread independently. The

output of the filters is fed into an oversampled Saturation circuit before being blended

with the input signal in the "FX Mix" stage.

5.4.1 Spreadbands (Filter) Controls

•

Cutoff

sets the center frequency of the filter array in MIDI note number (69= 440hz).

DEEP FREQ - Manual - 37

Table of Contents