Analysis (And Amplitude) Controls; Envelope Follower Controls; Output Controls; Frequency Maps - Native Instruments Deep Freq Manual

• RM Pitch sets the pitch of the modulator for Ring-Modulator mode.
• FRQ Map selects the frequency map used, and thus defines the pitches/frequencies of
the 16 Oscillators/Filters. You can think of this as a "Spectrum selector". See below
for details on the frequency maps.
• RND adjusts the Amount of pitch/frequency randomisation applied.

5.3.2 Analysis (and Amplitude) Controls

• Mode selects Analysis Mode 1, 2 or 3.
•
Scale scales the control signal used for selecting envelopes. This allows bringing the
control signal into the range needed to play back all 16 Oscillators/Filters. Larger
Scale value = higher number Oscillator/Filter gets triggered (well, sort of....).
• Attack sets the attack time of the envelopes.
• Decay sets the decay/release time of the envelopes.
• Hold sets the hold time of the envelopes. For Mode 1 this also translates into lower
trigger rates at higher hold values.

5.3.3 Envelope Follower Controls

•
Attack: Envelope Follower Attack Time.
• Release: Envelope Follower Release Time.
•
SC Scale: Scales the output of the envelope. Use this to adapt the Envelope Follower
sensitivity to input level.
• Exp Envelope: Follower output is raised to this power. Higher values tend to expand or
exaggerate the waveform, lower values tend to compress it.

5.3.4 Output Controls

FX Mix adjusts the Dry/Wet balance for the entire effect.

5.3.5 Frequency Maps

• Map 0: Harmonic Series, normal order, factors 1...16
The Ensembles
Plagiarism
DEEP FREQ - Manual - 34