NEC Storage Manager User Manual page 143

For example, when logical disk numbers 0, 1, 3, and 4 are in use, new logical disks are
numbered as follows:
When omitted:
When 0 specified:
When 10 specified:
[Change] button: Displays the screen which allows changing parameters. (Refer to Figure 7-66 "Change
Parameter Screen".)
[Next] button: Displays a message asking you to proceed.
[Back] button: Displays back the "Specify Number of LDs", "Specify the Capacity", or "Specify Number
of LDs and LD Capacity" screen
[Cancel] button: Displays a confirmation to ask whether you want to quit the wizard, then the wizard closes
if agreed.
Clicking the [Change] button on the "Setting Detail Parameter for LD Binding" screen displays the following
screen:
Chapter 7 Disk Array Configuration Setting
5,6,7...
2,5,6...
10,11,12...
IV-77