NEC Storage Manager User Manual page 326

Appendix F Batch Setup File
key.
(C) Target disk array Name
Describes the disk array name (up to 32 alphanumeric characters) targeted by the following
parameter, to continue from the key information [array].
(D) New disk array Name
Describes the disk array name to set following the target disk array + ', (comma)' when
executing the disk array name setting. It is unnecessary to specify this when the disk array
name is not to be set (i.e., when changing only the LD type/name or the port name).
Describing a name in excess of 32 characters for the disk array name will end in error.
(E) Key information (LD)
Describes [ld] as the key information indicating that the following parameter is the setup
information for LDs. (The information following [ld] is valid until the next [array] or [ld]
appears.)
(F) New LD Type/Name
Sets the format and LD names for the LDs in the target disk array ((c) above) described
before describing this parameter. Describes "nnnnh (nnnn: LD number in four
hexadecimal digits)" as the ID information of the target LDs. Describes the newly set
format (refer to Table 15-1), ", (comma)" and LD name to continue from ", (comma)".
Describing a name in excess of 24 characters for the LD name will end in error.
When making settings for other LDs in the same disk array, describe the information to be
set in the same format on the succeeding line.
On the ACOS-4 system, make sure that the LD identifier name matches the LD name on the host.
(G) Key information (port)
Describes [port] as the key information indicating that the following parameter is the setup
information related to ports. (The information following [port] is valid until [array] or [ld]
appears.)
36