NEC Storage Manager User Manual page 257

Only a piece of path information can be selected at a time from the "Current Path Info" display area.
To apply settings for the disk array, click the [OK] button.
[Delete] button
Selecting Delete target path information from the "Current Path Info" display area and clicking this button will
delete the selected path information from the "Current Path Info" display area.
Only a piece of path information can be selected at a time from the "Current Path Info" display area.
To apply settings for the disk array, click the [OK] button.
[OK] button
Clicking this button will display the operation confirmation message, and path information shown in the "Current
Path Info" display area will be applied to the disk array.
The WWPN of path information can be set even when the set value is different from the WWPN of the business
server HBA which actually accesses logical disks. Therefore, pay careful attention not to set a wrong value.
Application of path information immediately reflects on the Disk Array. Therefore, if setting information is wrong,
there is a possibility that accessing from the business server may not be possible. Pay careful attention to this.
Especially, when settings are wrong for deleting or replacing path information, the business server may suddenly
stop recognizing the logical disk in use. It is necessary to perform operation after checking the operation state.
Furthermore, stop business or the business server according to the necessity.
[Cancel] button
When changes made on this dialog screen are not set for the disk array, the following dialog screen will appear and
the execution of the operation will be confirmed.
Figure 10-9 Confirmation Dialog Screen 4
IV-191
Chapter 10 Access Control Operations