NEC Storage Manager User Manual page 105

(5) Specifying the way of binding the logical disks
Clicking the [Next] button on the "Free Area Selection" screen displays the "Binding Method" screen.
This screen is displayed when you select a pool without multiple unused areas or dynamic pool and click the
[Next] button on the "Pool Selection" screen.
Figure 7-34 Specifying the Way of Binding the Logical Disks
Specify one of the following ways of binding the logical disks:
Only specify the number of LDs (default)
Specify the number of logical disks to bind in the pool.
Only specify LD capacity
Specify the capacity of each of the logical disks to bind in the pool. You can specify a recommended
capacity, set the capacity same with that of a logical disk already bound, or directly designate any value for
the capacity.
Specify both the number of LDs and LD capacity
Specify any desired values for the number of logical disks and the capacity of one logical disk.
To bind a control volume, check this option.
Chapter 7 Disk Array Configuration Setting
IV-39