Removing The Mdc Modem Module - NEC Packard Bell EasyNote M5 Disassembly Manual

3. Disconnect all connector from the Main Board and remove the screw holding the
heat plate as shown in Fig. 39.

Removing the MDC Modem Module

To remove the MDC Modem Module, first remove the Main Board (see
Main Board), then perform the following steps:
1. Remove the screws retaining the MDC Modem as shown in Fig. 40
Fig. 40 Removing the screws retaining the MDC Modem
2. Carefully lift up the MDC modem module.
3. Disconnect the cable attached to the MDC modem and put the modem aside.
Note: The location of the MDC modem in the EasyNote M5 is different than the one in
the EasyNote M7. On the M7 the MDC modem is located under the touch pad. On the
M5 the MDC modem is next to the PCMCIA slot.
Fig. 39 Separating Main board
Packard Bell EasyNote M5/M7 Disassembly Manual
M2.5x7 black
Removing the
M2x4.5 black
24