Removing The Mdc Modem Module - NEC Versa M400 PB EasyNoteM5 Disassembly Manual

3. Disconnect all connector from the Main Board and remove the screw holding the heat plate as
shown in Error! Reference source not found.

Removing the MDC Modem Module

To remove the MDC Modem Module, first remove the Main Board (see
Board), then perform the following steps:
1. Remove the screws retaining the MDC Modem as shown in Fig. 40
2. Carefully lift up the MDC modem module.
3. Disconnect the cable attached to the MDC modem and put the modem aside.
Note: The location of the MDC modem in the Versa M400/EasyNote M5 is different than the one
in the EasyNote M7. On the M7 the MDC modem is located under the touch pad. On the M5 the
MDC modem is next to the PCMCIA slot.
NEC Versa M400/PB EasyNoteM5 M7 Disassembly Manual
Separating Main board
Fig. 39
Removing the screws retaining the MDC Modem
Fig. 40
Removing the Main
M2.5x7 Black
M2x4.5 Black
Page 26