Table of Contents
Advertisement
Batteries that do not indicate capacity in % (percent)
Such batteries indicate the battery level in voltages.
• 13.5 V: Indication of current battery voltage.
24 Media remaining memory display
Indicates a remaining 3D recording time based on the
remaining time on the P2 cards inserted in card slots L
and R.
• Indicates remaining time in 1-minute increments
from 0 to 999 minutes. 999 minutes and longer time
periods are also indicated as 999 minutes.
• The display blinks when 2 minutes or less time is left.
• The display does not appear while calculating the
remaining time.
25 Media information display
Indicates the slots that contain P2 cards and general
information on the media.
• L R light green:
P2 card ready for recording
• L R light green in reverse:
P2 card selected for recording
• L R flash rapidly in white:
The card is being recognized
No card inserted
• - :
Write-protected
• P :
Full
• F :
Cannot recognize
• X :
P2 card in an invalid format (formatting will
• E :
take care of this problem)
26 Operation status display
Recording
• REC:
• PAUSE:
Recording standby
Playback pause
• h :
Play
• q :
• y (t ) :
Fast-forward/fast-forward playback (fast-
reverse/fast-reverse playback)
• 4X y (4X t ) :
4x speed search (4x speed reverse search)
• CLIP h q (CLIP w h ) :
Clip forward (clip reverse), cue up of single
clips
During DISPLAY OFF, only the REC and special
recording displays are shown at the top right.
Specialrecordingdisplay
The indication "I-" appears when the interval recording
is set to ON.
0
Center Information Display
The following information displays are provided.
P2 card recording and playback data
indications
•BOS
Beginning of stream. No more data is available in the
rearward playback direction.
•CANNOTPLAY
Appears when playback is disabled.
•CARDERR(L)(R)(L/R):
This indicates trouble with the P2 card(s)
inserted in the card slot(s) shown has (have).
trouble.
•UPDATING:Reading card data
•CANNOTREC
Appears when recording cannot be started by pressing
the REC button.
•EOS
End of stream. No more data is available in the forward
playback direction.
•SHOTMARKON(OFF)(INVALID)
SHOT MARK appears when the user button or the lens
RET button to which it has been assigned is pressed.
•SYNCPOSIFAILED
Appears when the synchronization of the clip position
has failed.
Errors and warnings
Errors and warnings appear when something goes wrong
with the camera or a P2 card malfunctions. If the problem
cannot be solved by turning off the camera and turning it
back on, try replacing the card and if that does not help, it
may be necessary to consult your supplier.
•DIRENTRYNGCARDL(R)(L/R)
This message indicates that the directory on the card
has become corrupted and that normal recording
cannot be guaranteed if operation continues. Make a
quick backup of card data and reformat the card.
•FANSTOPPED
FAN (1, 1/2, 1/3, 2, 2/3, 3, 1/2/3)
This indicates an error with the fan. The fan is under
suspension.
•FORMATERR!
This indicates a P2 card that does not meet the P2 card
standard
•HIGHTEMPERATURE
A high-temperature error is detected.
•INCOMPATIBLECARD
This message indicates that the inserted card does not
meet required standards and cannot be used.
•LOWBATTERY
This message indicates that the battery is depleted.
Advertisement
Table of Contents
