Nur für den internen Gebrauch
Configuring the optiPoint IPadapter on the optiset E.
●
The same procedure is adopted for the configuration of optiPoint IPadapter on the optiPoint
500 (phone-side) except that in each case, the other IP address is entered as the IP address
and IP partner address.
When you restart the computer, the IPadapter is set to "phone-side" by default as on
>
optiset E.
The IPadapter connected to the U
mode using the WEB interface after configuration has been completed. The IPadapt-
er resets itself after switching to "system-side" mode.
The IPadapter which is set to "system-side" mode can then only be administrated via
the Web browser and not via an optiPoint system telephone.
P31003-E8400-A100-3-7620
Service Manual
port should only be switched to "system-side"
P0
IP Adapter
Configuration Examples
7-39