Hard Floor Cleaning; Cleaning After Use - Bissell CLEANVIEW REACH 14U6 SERIES User Manual

O
perations

Hard floor cleaning

(Select models only)
1. Remove the collection tank (refer to steps
2a and 2b on page 8).
2. Attach the hard floor tool by hooking it
into the front of the removable nozzle and
rotate until it snaps firmly in place.
3. Replace the collection tank. Be sure to
attach the two latches.
4. Fill the solution tank with warm tap water
to the WATER fill line. Fill the rest with
BISSELL 2X Hard Floor Solutions™ to
FORMULA fill line.
5. Follow steps 1-8 under "Carpet Cleaning"
on page 7 to continue cleaning.

Cleaning after use

1. Unplug the unit.
2. Rinse collection tank thoroughly.
2a. Remove ReadyTools Dial by
rotating it halfway between "TOOlS" &
"FLOOR CLEANING."
2b. Pop out knob by using the opening on
the back of the tank. Rinse and replace knob
and collection tank.
3. Remove tank vent & foam filter (located on
top of the collection tank) and rinse.
4. Clean nozzle window by lifting latch and
removing from machine. Rinse under run-
ning water.
5. When finished replace nozzle and secure
with latch.
NOTE: For best results, it is recom-
mended that the nozzle is cleaned
after each use.
6. Remove lint and hair from red gasket in
base of unit. (Do not remove gasket)
7. Replace the collection tank to the base of
the machine and secure with latches.
10
w w w . b i s s e l l . c o m
2.
WARNING:
To reduce the risk of fire and
electric shock- when cleaning
a hard floor, the BISSELL hard
floor tool (203-5548) must
be used and it must only be
used with BISSELL 2X Hard
Floor Solutions cleaning fluid
intended for use with this
appliance.
2a.
2b.
3.
5.
4.
2b.
4.
6.