Table of Contents
Advertisement
C-4 Upholstery Cleaning
1. Important! If using to wet clean upholstery,
check the upholstery tags before hand.
a. Check manufacturer's tag before
cleaning. "W" or "WS" on the tag means
you can use your cleaner. If the tag
is coded with an "X" or an "S" (with a
diagonal stripe through it), or says "Dry
Clean Only", do not proceed with wet
cleaning. Do not use on velvet or silk.
If manufacturer's tag is missing or not
coded, check with the furniture maker
or the furniture dealer.
b. Check for colourfastness in an
inconspicuous place.
c. If possible, check upholstery stuffing.
Coloured stuffing may bleed through
fabric when wet.
d. Plan activities to allow upholstery time
to dry.
e. Vacuum thoroughly.
2. Refer to the "Getting Ready to Wet Clean",
section C-2.
3. Attach desired wet cleaning tool
directly to grip.
4. Place tool directly on surface. Press spray
trigger to spray cleaning solution while
pulling tool towards you.
5. Keep nozzle of tool firmly against surface
and continue to make slow forward and
backward wet passes until no more dirt can
be removed. Caution: Do not overwet.
6. Release spray trigger and make slow
forward and backward passes over same area
to remove any residual water.
7. Continue to clean entire surface.
8. If machine loses suction, stop wet
cleaning and check collection tank level.
Empty if full.
9. If machine stops spraying, turn off
wet clean button immediately and check
solution tank level. Refill if empty.
10. Refer to section D for machine
care instructions.
C-5 Hard Floor Cleaning
1. Open Quick Release hose door, turn
cleaning mode selector to "WET CLEAN",
then close hose door.
2. Remove tool caddy from back of
cleaner if in place.
3. Unscrew measuring cap from solution
tank. Fill solution tank with hand hot tap
water to fill line. Add one full measuring cap
of BISSELL hard floor cleaning formula then
screw cap tightly back onto solution tank.
IMPORTANT: Be sure to use BISSELL hard
floor cleaning formula when cleaning sealed
hard floor surfaces.
4. Place solution tank back in the cleaner.
5. Attach Microfibre mop pad to quick dry
hard floor tool by attaching ends to Velcro
strips on top of tool.
NOTE: Be sure top of mop pad is positioned
below brushes on hard floor tool.
6. Attach quick dry hard floor tool to end
of the wand.
7. Plug into a proper electrical socket and
push power and wet clean buttons on.
8. Place tool directly on the hard floor
surface, resting on the pad.
9. Press spray trigger to moisten mop pad
with cleaning solution.
Caution: Do not oversaturate.
10. Move tool back and forth across floor;
using solution, brushes and mop pad to clean.
Press spray trigger as needed.
11. With spray trigger released, swivel tool
forward and pull back across cleaned floor to
remove any residual water. This will create the
best suction and will help get the hard floor
surface as dry as possible.
12. Continue to clean entire floor.
13. If cleaner loses suction, stop wet cleaning
and check collection tank level. Empty if full.
14. If cleaner stops spraying, turn off wet
clean button immediately and check
solution tank level. Refill if empty.
15. When finished, be sure to remove
Microfibre mop pad and clean by hand
or machine wash as needed. Allow to
dry completely before next use.
16. Refer to section D for machine
care instructions.
www.BISSELL.eu
9
Advertisement
Table of Contents
