HAS A Subject to the *EXCEPTIONS AND EXCLUSIONS identified EXCEED THE PURCHASE PRICE OF THE PRODUCT. below, upon receipt of the product BISSELL will repair or Some states do not allow the exclusion or limitation of POLARIZED replace (with new or remanufactured components or incidental or consequential damages, so the above limitation products), at BISSELL’s option, free of charge from the date...
OPERATIONS OPERATIONS FLOOR SETTINGS PRESET: FLOOR/STAIRS In floor-cleaning mode, the FLOOR preset can be POWER INDICATORS SUCTION ADJUSTMENT pressed = Max. suction power + Brush roll OFF. Use this setting on hard floor surfaces. POWER INDICATOR BRUSH ROLL ON/OFF In removed and parked mode, the STAIRS preset can Blue LED indicates that AC plug is Press this button to turn brush roll be pressed = Med.
Page 5
OPERATIONS OPERATIONS TO CHARGE THE UNIT USE TELESCOPIC HANDLE Pull up handle Charging indicator illuminates Click to lock Plug in power cord and charge cycle on battery indicator will be shown Slide switch to standby connected to live 120V AC Push down handle Pull back handle release Pull back handle release...
Page 6
OPERATIONS OPERATIONS CORDLESS MODE CORDED MODE Press the power Press the power Press foot pedal Enjoy the freedom of Press foot pedal button to turn button to turn Once the product is Plug in the power and recline cordless vacuuming and recline Vacuum in corded mode machine on...
OPERATIONS OPERATIONS TOOL SELECTION ABOVE-FLOOR CLEANING Remove hose handle from docking foot Attach desired cleaning tool to end of hose Release telescopic wand Release dusting brush Release crevice tool Clean in corded or cordless mode, following operations instructions Release stair tool Crevice tool Dusting brush Telescopic wand with tool...
Page 8
OPERATIONS OPERATIONS LIFT-OFF® CAPSULE LIFT-OFF® CAPSULE ABOVE-FLOOR CLEANING To re-dock, place removable Lift the removable capsule capsule onto foot, aligning the hose and docking station. Press capsule release pedal and Step onto capsule release pedal Push down. Click to lock use the combination of stretch hose, tool, and cordless freedom to vacuum where you want...
OPERATIONS MAINTENANCE & CARE LIFT-OFF® CAPSULE STAIRS EMPTYING DIRT CUP Hold tank over trash can then press dirt cup door Remove stair tool from foot Attach stair tool to hose Vacuum the stairs latch to open dirt cup door and release debris Empty dirt into trash can Push dirt cup release latch and pull out cup...
MAINTENANCE & CARE MAINTENANCE & CARE CLEANING FILTERS CLEANING DIRT CUP Remove filter and tap to release large debris. Replace Separate by twisting the top and bottom in opposite directions filter by inserting in dirt cup Wipe the cyclone clean with a damp cloth. and turning counterclockwise Note: be sure the cyclone is fully dry before replacing dirt cup and operating vacuum (until the arrows on the...
Page 11
MAINTENANCE & CARE MAINTENANCE & CARE CLOGS CLOGS Removing blockages from duct located on the underside of the foot assembly Unscrew stretch hose end from Lift-O ® capsule to check for and remove blockages Ensure that the large stretch hose rib aligns with the slot in the foot Remove stretch hose from foot assembly Push stretch hose...
MAINTENANCE & CARE FEEDBACK INDICATION BRUSH ROLL All 6 LEDs OFF with AC power indicator LED ON. Accessing brush roll for cleaning and brush roll belt in case of breakage Indicates AC is connected and ON when illuminated. Battery is fully charged. Might occur while battery stabilizes after AC connection is made.
Disconnect the main power supply and slide storage/standby switch to STORAGE mode. Inspect along the entire air path and remove blockages, empty the dirt cup, If your BISSELL product requires service, please contact consumer care before returning the product. LED 3 Over heat >60°C...