Deep Reach Tool Attachment - Bissell CLEANVIEW REACH 14U6 SERIES User Manual

O
perations
Cleaning with Attachments continued
6. Clean by pressing the spray trigger
to spray solution onto the area to be
cleaned. Slowly move the tool back and
forth over the soiled surface. Release
the spray trigger to suction dirty water.
Continue to clean in the area, working
in small sections, until dirt is removed.
Caution: Do Not Overwet.
7. When finished cleaning, remove and
rinse tool(s) in clean, running water.
8. It is recommended that you suction clean
water from a bowl to rinse out the hose.
9. Lift end of hose and stretch out to ensure
all water is cleared from hose.
10. Wrap flex hose around hose wrap.
11. Empty collection tank and rinse out, fol-
lowing instructions on page 10 under
"Cleaning after use."
12. Return ReadyTools dial to "FLOOR
CLEANING" setting.

Deep reach tool attachment

(Select models only)
1. Follow the instructions on page 7 for
Filling the tank.
2. Follow instructions 1-5 on page 8 under
"Cleaning with attachments".
3. Set tool on stain and press the spray
trigger to spray trigger solution onto the
area to be cleaned.
4. Slowly move the tool back and forth over
the soiled surface, keeping the tool in con-
tact with the carpet.
5. Release the spray trigger and move tool
slowly over the soiled area to suction up
water and dirt.
6. Continue to clean the area, working in
small sections, until no more dirt can be
removed.
7. Remove tool from hose when finished.
Clean under warm water before storing
8. Follow cleaning attachment instructions
on pages 8 and 9, instructions 8-12.
w w w . b i s s e l l . c o m
3.
5.
7.
9