Hard Floor Cleaning - Bissell CLEANVIEW POWERBRUSH 37E3G User Manual

Operations

Hard Floor Cleaning

Your carpet cleaner includes a hard floor tool
and Wash & Shine Hard Floor Formula. The
hard floor tool provides effective cleaning for
linoleum, vinyl, and tile floors. Caution: Do not
use on unsealed hardwood floors.
1. Thoroughly vacuum or sweep floor to pick
up any debris.
NOTE: Prior to filling with formula and water be
sure all carpet cleaning formula is thoroughly
rinsed from the 2-in-1 water tank.
2. Add 44mL of Wash & Shine Hard Floor
Formula per 1L of hand hot tap water. Do not
boil or microwave. Your CleanView PowerBrush
has a 2.8L tank.
3. Attach the hard floor tool to the bottom
of the machine by hooking it into the nozzle
and swinging it down until it clicks into place.
3.
4. Be sure the ReadyTools dial is set to
FLOOR CLEANING.
5. Plug into an outlet and turn the power on.
6. Plan your cleaning route to leave an exit path.
Be sure to allow adequate time for floors to dry.
7. While pressing the spray trigger, make one
Hard Floor Tool
slow forward wet pass and another back.
Caution: Do Not Overwet.
8. Repeat the motion without pressing the
spray trigger using the hard floor tool to
squeegee and suction up the dirty water.
9. When finished, remove hard floor tool,
rinse and let dry before storing. Refer to the
Maintenance and Care section on page 12 for
machine clean up and storage instructions.
11
www.BISSELL.com.au