Hard Floor Cleaning - Bissell READYclean 39Q6 User Manual

O
perations
carpet cleaning continued
6. Release the spray trigger and make one
slow forward and backward pass over
the same area.
7. Repeat steps 5 and 6 until solution
being pulled up appears clean.
8. Empty the collection tank when dirty
water reaches the full line, or when
the solution tank is empty.
empty the collection tank
1. With foot press the red power lever, to turn
off and unplug power cord from outlet.
2. Remove the collection tank from base of unit.
2a. Release collection tank latches
(on each side) by pulling up from the
bottom of latch and then out.
2b. Carefully remove tank by lifting
up on the tank handle.
3. Carry collection tank to a toilet or
sink. To empty, pour out contents
using opening at back of tank.
4. Rinse collection tank thoroughly and
replace on unit.
5. Refill solution tank and continue cleaning.

Hard floor cleaning

(Select models only)
1. Remove the collection tank (refer to
steps 2a and 2b on page 6).
2. Attach the hard floor tool by hooking it
into the front of the removable nozzle
and rotate until it snaps firmly in place.
3. Replace the collection tank. Be sure to
attach the two latches.
4. fill the solution tank with hand hot (not
boiling) tap water to the WATER fill line.
fill the rest with BISSELL 2X hard floor
Solutions™ to foRmULA fill line.
5. follow steps 1-8 under "Carpet Cleaning"
on page 6 to continue cleaning.
w w w . b i s s e l l . c o m
2a.
3.
WaRning:
To reduce the risk of fire and
electric shock when cleaning
a hard floor, the BISSELL
hard floor tool (203-5705)
must be used and it must
only be used with BISSELL 2X
hard floor Solutions cleaning
fluid intended for use with
this appliance.
2.
2b.
4.
7