Rip - Billion BiPAC 7800(N)X(L) User Manual

RIP

RIP, Router Information Protocol, is a simple Interior Gateway Protocol (IGP). RIP has two versions,
RIP-1 and RIP-2.
Interface: the interface the rule applies to.
Version: select the RIP version, there are two versions, RIP-1 and RIP-2.
Operation: RIP has two operation mode.
 Passive: only receive the routing information broadcasted by other routers and modifies its
routing table according to the received information.
 Active: working in this mode, the router sends and receives RIP routing information and
modifies routing table according to the received information.
Enable: check the checkbox to enable RIP rule for the interface.
Note: RIP can't be configured on the WAN interface which has NAT enabled (such as PPPoE).
Click Apply to apply your settings.
182